Dinan Cold Air Intake – 2012-2016 BMW M5

Overview

The F10 M5 Dinan high flow carbon fiber cold air intake, like most Dinan products, has a sleek and functional appearance that embodies high performance. The F10 M5 cold air intake allows cool outside air to be pushed into the engine via a pair of supplemental carbon fiber intake ducts located at the front of the engine bay. The M5 cold air intake system was carefully designed within tight packaging constraints and in consideration of ideal aerodynamic diffusing angles to optimize the efficiency and performance of this induction system. Each duct leads combustion air through a custom-designed intake assembly that has a larger than stock metered air flow housing as well as a Dinan conical air filter with a 77% larger capacity. Dinan engineers have painstakingly developed custom tooling to ensure the entire Dinan cold air intake system is sealed like a factory replacement, thereby preventing hot air from the engine compartment to compromise its effectiveness. The stock air inlets are left intact and fully functional to provide a new total of four air intakes into the engine for maximum airflow. Improved induction airflow offered by Dinan cold air intake systems increases engine performance, even more so if used in combination with other performance-enhancing Dinan products.

Features:

• More Power: + 13 HP, + 7 LB-FT (coupled w/ engine tuning)
• Carbon fiber air box lids and intake ducts
• Entire Dinan Intake system is sealed like a factory replacement to ensure only cold outside air and not hot air from the engine compartment is being utilized
• Dinan proprietary Injection molded Dinan MAF housings are larger than stock
• Stock air filters are replaced with 77% larger Dinan conical air filters for optimum flow
• Additional secondary inlets for additional air flow
• Stock System Stays Completely Functional

Specs

Service Parts

Dinan Replacement Filter for High Flow Carbon Fiber Intake – 2012-2018 BMW M5/M6

Emissions

7

This part is legal under the provisions of EPA’s Tampering Policy dated November 23rd, 2020. The company has reasonable basis (test results) to verify that this product allows the vehicle to operate within legal emissions standards and is therefore legal to be sold for on-street use in all states that accept the legal provisions of the Clean Air Act and the EPA Tampering Policy. This product is NOT LEGAL FOR SALE OR USE IN THE STATE OF CALIFORNIA. Testing with the California Air Resources Board, in order to achieve 50-state compliance, is pending with CARB. Once testing is complete with California, and an E.O. number is issued, this product will be updated to 50-state legal status.

Tech Resources

Instructions for Part# D760-0035

Specialized Dinan tool kit required for installation (DT763-0083 or DT763-0084)

Applications

2016 BMW M5 Base /4.4L V8 Sedan
2015 BMW M5 Base /4.4L V8 Sedan
2014 BMW M5 Base /4.4L V8 Sedan
2013 BMW M5 Base /4.4L V8 Sedan
2012 BMW M5 Base /4.4L V8 Sedan